2022-12-08T20:37:44Zhttps://nagoya.repo.nii.ac.jp/oaioai:nagoya.repo.nii.ac.jp:000074772022-10-21T01:22:11Z高強度GFRPのモードII層間はく離疲労き裂進展におよぼす応力比の影響Effect of Stress Ratio on Growth Behavior of Mode II Interlaminar Fatigue Cracks in High Strength GFRP松原, 剛MATSUBARA, Go尾野, 英夫ONO, Hideo田中, 啓介TANAKA, Keisukeopen access日本機械学会本文データは学協会の許諾に基づきCiNiiから複製したものである。Mode IIFatigueDelaminationGFRPStress RatioEnergy Release RateCrack PropagationInterlaminar ShearComposite MaterialThe mode II fatigue crack growth behavior from delamination was investigated with UD laminates (made of unidirectional laminates) and C laminates (made of unidirectional laminates and cloth laminates) of high strengh glass fiber reinforced plastics (GFRP). Fatigue crack growth tests were carried out by end notched flexure speciments at the stress ratios R=0.3, 0.1, -0.5, and -1. In UD laminates, the theshold of energy release rate range, ⊿GⅡth, of fatigue crack growth was independent of the stress ratio. In C laminates, the ⊿GⅡth value at negative stress ratios was about four times of that at positive stress ratios. In C laminates, a fatigue crack propagated along the interface of the unidirectional laminate at positive stress ratios, while along the interface of the cloth cloth laminate at negative stress ratios. When the stress ratio was negative, the fracture surface of C laminates was rough because of the resin rich area of fabric crossing, and this roughness shielded the crack tip, restricting the shearing deformation near the crack tip. Thus the crack growth resistance of C laminates at negative stress ratios in much larger than that at positive stress ratios.日本機械学会2004-04jpnjournal articleVoRhttp://hdl.handle.net/2237/9159https://nagoya.repo.nii.ac.jp/records/7477http://ci.nii.ac.jp/naid/110004998724/0387-5008日本機械学會論文集 A編70692580587https://nagoya.repo.nii.ac.jp/record/7477/files/JsMecEngA_70-692-580.pdfapplication/pdf1.4 MB2018-02-19