2024-03-28T13:22:08Z
https://nagoya.repo.nii.ac.jp/oai
oai:nagoya.repo.nii.ac.jp:00006814
2023-01-16T04:46:32Z
643:835:836:837
Shearing performance of plywood nailed walls under cyclic loading
正負繰り返し負荷を受ける合板釘着張り耐力壁のせん断性能
今西, 祐志
17837
IMANISHI, Hiroshi
17838
佐々木, 康寿
17839
SASAKI, Yasutoshi
17840
正負繰り返し加力
耐力壁
せん断性能
繰り返し変形量
繰り返し数
cyclic load
plywood nailed wall
shearing performance
cyclic deformation value
number of cycles
1997-12
合板釘着張り耐力壁について一定変位での正負繰り返し加力による疲労試験を行い、せん断荷重と変形との関係を求め、繰り返し変形量および繰り返し数と耐力との関連について考察した。正負繰り返し加力による疲労試験では、繰り返し数の増加にともなってせん断荷重のピーク値は対数的に低下し、大きな繰り返し変形を与えた方がより大きく低下した。残留変形は、繰り返し変形量に関係なく繰り返し50回あたりまでは増加し、その後減少に転じ、大きな繰り返し変形を与えた方がより急激に減少した。疲労試験により得られたせん断荷重 – 見かけのせん断変形角曲線から求めた吸収エネルギーは、繰り返し数の増大とともに減少し、とくに繰り返し3回程度で激減した。疲労試験後の単調増加加力試験では、より大きな繰り返し変形履歴をもった壁体の方が性能の低下が大きいことが明らかとなった。また壁倍率については、繰り返し変形量が±1/300 rad の場合には1.95、繰り返し変形量が±1/120 rad の場合には0.738であり、前者は後者の約2.6倍であった。
Racking tests under the conditions of cyclic loading with constant deformation (± 1/120 rad and ± 1/300 rad) and monotonous increase of loading were conducted on plywood nailed walls. The shearing performance of the walls is discussed in relation to the cyclic deformation value and to the number of cycles. The cyclic loading fatigue tests showed that maximum values for the shearing force decreased logarithmically with increases in the number of cycles and that the decreasing ratios were larger for ± 1/120 rad cyclic deformation. The residual deformation increased untill about the 50th cycle, regardless of the cyclic deformation value, and then decreased with increases in the number of cycles. The absorbed energy, which were calculated from the shearing force-deformation curves obtained from the fatigue tests, decreased as the number of cycles increased, the decrease being especially sharp untill about the 3rd cycle. The monotonous increase loading tests after the fatigue tests showed that the shearing performance of the walls decreased with increases in the cyclic deformation value. For example, the shear load factor in case of ± 1/300 rad cyclic deformation was 1.95, and that in case of ± 1/120 rad cyclic deformation was 0.738, the former being about 2.6 times larger than the latter.
農林水産研究情報センターで作成したPDFファイルを使用している。
departmental bulletin paper
名古屋大学農学部附属演習林
1997-12
名古屋大学森林科学研究
16
7
16
http://hdl.handle.net/2237/8488
1344-2457
jpn
http://rms1.agsearch.agropedia.affrc.go.jp/contents/JASI/pdf/academy/57-2255.pdf